 |
|||||||||||||||||||
|
|||||||||||||||||||
|
Paint right over StrongArmSprays
on Rust or Any metal or surface. It's a Simple 1, 2, 3 Then Paint it Process as shown right here... |
|||||||||||||||||||
 |
|||||||||||||||||||
| 1) We Take the hunk of rusty iron and Hit it with the StrongArm Sprays. Note how nicely the StrongArmSprays applies with a straight stream from a distance. 100% of the StrongArm goes on the surface with no loss.
The other spray products have a hair spray nozzle that sprays a mist which loses nearly all the spray into the air as pollution. |
|||||||||||||||||||
 |
|||||||||||||||||||
| 2) Brush the surface of the metal with a wire brush for up to a half minute. |
|||||||||||||||||||
 |
|||||||||||||||||||
| 3) Wipe the surface with an old cotton cloth, towel or rag. The surface is now undercoated and READY FOR PAINT. Remember: DO NOT remove the StrongArmSprays with any paint removers thinners and cleaners. That is a waste of material and expense. |
|||||||||||||||||||
 |
|||||||||||||||||||
| Lightly Apply Enamel or Lacquer paint by spray or brush and let it stand. Allow time for drying. Put piece out in the sun or warm area to cure paint. StrongArmSprays Penetrants will carry the paint into the surface deep below the paint. The painted surface will not rust anymore.
It's That simple. |
|||||||||||||||||||
  |
